Product ID:D1200 PART 1 "D"-(PART OF 9P224C-2SEC2 KIT)
MSDS Date:01/01/1985
FSC:5805
NIIN:01-023-1583
Kit Part:Y
MSDS Number: BGFFS

PSI TELCO INC.

3333 N SAN FERNANDO BLVD
BURBANK, CA 91504
US

Emergency Phone: 213-843-7944

Info Phone: 213-843-7944

Cage: 34261

PSI TELECOMMUNICATIONS INC.

UNKNOW BURBANK, CA 91504 US

Telephone: 800-426-8688

Cage: 3V085

METHYLENE BISPHENYL ISOCYANATE (MDI) (SARA III)

CAS: 101-68-8

RTECS: NQ9350000

Fraction By Weight: 7.5%

OSHA PEL C, 0.02 PPM

ACGIH TLV: 0.005 PPM; 9192

EPA Report Quantity: 1 LB

DOT Report Quantity: 1 LB

HIGH MOLECULAR POLYMERS OF.SIMILAR STRUCTURE TO EACH OTHER

Fraction By Weight: 35.6%

NON AQUEOUS SOLUTION,HAZARD UNKNOWN,UNIDENTIFIED;% WT BY

Fraction By Weight: 56.9%

Effects of Overexposure:CAUSES RESPIRATORY IRRITATION,HEADACH,
SHORTNESS OF BREATH.MAY CAUSE EYE IRRIT BY VAPORS.

First Aid:REMOVE TO FRESH AIR. GIVE CPR/OXYGEN IF NEED. SKIN:WASH WITH
SOAP & WATER. EYES:FLUSH WITH WATER 15 MIN. KEEP WARM AND
QUIET.CONSULT PHYSICIAN IN CASE OF EYE IRRITATION.

Flash Point:425F-COC
Lower Limits:UNK
Upper Limits:UNK
Extinguishing Media:CO2, FOAM, DRY CHEM & H2O FOG.
Unusual Fire/Explosion Hazard:NONE KNOWN

Spill Release Procedures:EVACUATE UNPROTECTED PERSONS. STOP LEAK. H2O
SPRAY TO COOL CONT/DIVERT SPILL FROM FIRE/HEAT. PROVIDE
VENTILATION. ABSORB W COMMERCIAL ABSORBENT,SHOVEL INTO METAL DRUMS.
LG SPILL:DIKE W COMMERCIAL ABSO RBENT, MFR NOTES:CLEAN UP SIMILAR
TO ANOIL SPILL

Handling and Storage Precautions:AVOID STORAGE OVER 90F.KEEP CONTAINERS
TIGHTLY CLOSED.
Other Precautions:NONE KNOWN.

Respiratory Protection:NONE SHOULD BE NEEDED
Ventilation:NO SPECIAL REQUIREMENTS W ADEQUATE VENT.
Protective Gloves:AS REQUIRED
Eye Protection:SAFETY GLASSES
Other Protective Equipment:NONE
Supplemental Safety and Health
THIS DATA DESCRIBES PART 1 OF 2 PART EPOXY COMPOUND IN SPLICE CABLE KIT
#9P224C-2SEC2 CONSISTS 5 OR 6 OTHER HARDWARES IN ADDITION TO 2 PART
BONDING COMPD;BOTH PARTS MAKE 1200 GMS.

HCC:N1
Vapor Pres:UNK
Vapor Density:1.3
Spec Gravity:1.04
Evaporation Rate & Reference:0.11(ETHER=1)
Appearance and Odor:CLEAR SHARP ODOR LIQUID
Percent Volatiles by Volume:0

Stability Indicator/Materials to Avoid:YES
NONE
Stability Condition to Avoid:HIGH TEMPERATURES,IGNITION SOURCES
Hazardous Decomposition Products:NONE NOTED,BUT EXPECT CO, CO2, H2O.
Conditions to Avoid Polymerization:UNK

Waste Disposal Methods:KEEP IN COVERED DRUMS,PENDING DISPOSAL. HANDLE &
DISPOSE IN FULL COMPLIANCE WITH ALL APPLICABLE
INTERNATIONAL,FEDERAL,STATE, & LOCAL REGULATIONS.MFR NOTES:NORMAL
DISPOSAL METHODS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.